IllumiTrack was developed as an inexpensive wireless hand tracking device, mainly for use with Mocopi, to make motion capture for 3D Vtubers more accessible. This is DIY data for assembling a prototype. This product is for motion capture, not for VR. Before assembling, be sure to read the creation instructions at the URL below carefully. ------------------------------------------ 7/3 IMU also supports MPU6050. 7/4 Modify case STL data ------------------------------------------ About IllumiTrack You can track finger bending and hand rotation inexpensively. By using CdS, the cost of sensors for each finger has been significantly reduced. WiFi settings and destination settings can be accessed and set from a smartphone or laptop. You cannot open your fingers, but some adjustments can be made on the software side. Since the finger bending uses a light sensor, please use it with the room lights on. You can operate the keyboard and mouse, but your fingers may bend unintentionally. In addition, some actions such as clapping may cause your fingers to bend unintentionally. Since it is used by holding it, it is not suitable for playing musical instruments. About Flexiosyncer This software can directly receive MocopiUDP and easily synthesize motion with IllumiTrack tracking. It can send motion using VMC protocol. It can also display the remaining battery level and initialize the device. The control software Flexiosyncer and IllumiTrackFW are for IllumiTrack only. They are not compatible with devices from other manufacturers. The sensors on the prototype PCB are spaced 15mm apart from the index finger to the little finger. If the spacing is narrower or wider than this, tracking may not function properly. Please feel free to modify the data and use it. How to make IllumiTrack https://note.com/kirisamenanoha/n/n87c47b92dd89 [Caution/Disclaimer] The IllumiTrack DIY Kit is in the prototype stage. The developer has assembled and used it to confirm that there are no major problems before releasing it. However, since it is fan-made hardware, we are not responsible for any loss or damage caused by the use of this kit. Please use at your own risk. Please understand this before creating.